DirectX: Direct3d Acceleration Test Failed at Step 5
View products that this article applies to.
SYMPTOMS
When you use the Microsoft DirectX Diagnostic Tool and run the Direct3D test, you may receive the following error message:
failure at step 5 (get device caps): hresult = 0x8876086a 3-d not available
CAUSE
This issue occurs because the Direct3D settings indicate that Direct3D is enabled, when in fact it is disabled.
RESOLUTION
To resolve this issue, follow these steps: 1. If the DirectX Diagnostic Tool is not already open, follow these steps: a.  Click Start, and then click Run.
b.  In the Open box type DXdiag, then click OK.

2. Click the Display tab.
3. Verify that Direct3D Acceleration is listed as Enabled and the button to the right indicates Disable.
4. Click Disable.
5. When you receive the following warning, click OK:
This will re-enable hardware acceleration of Direct3D for ALL display devices on your system.
6. Verify that Direct3D Acceleration is still listed as Enabled and the button to the right indicates Disable.
7. Click Disable
8. When you receive the following warning, click OK:
This will disable hardware acceleration of Direct3D for ALL display devices on your system.
Direct3d Acceleration now indicates that it is Disabled and the button to the right now indicates Enable. Click Enable one more time to properly start Direct3D Acceleration for your computer's display.
MORE INFORMATION
For additional information about the DirectX Diagnostic Tool, click the following article number to view the article in the Microsoft Knowledge Base:
190900 (http://support.microsoft.com/kb/190900/EN-US/) DirectX: Description of the DirectX Diagnostic Tool

--------------------------------------------------------------------------------

APPLIES TO
• Microsoft DirectX 9.0
• Microsoft DirectX 8.1b

Back to the top

Originally posted by gergermen at 2005-10-5 04:16 PM:
轉自Microsoft.com

Originally posted by gergermen at 2005-10-5 10:55 PM:
仲係唔得，就不如將DirectX完全卸載曬...

Originally posted by gergermen at 2005-10-6 10:18 AM:
裝返只兔子，等佢幫你搞返掂部腦，修...

Originally posted by gergermen at 2005-10-6 10:18 AM:
裝返只兔子，等佢幫你搞返掂部腦，修...

REGEDIT4

[HKEY_LOCAL_MACHINE\SOFTWARE\Super Rabbit\MagicSet]
"Registered Name"="SOFTREG13053"
"Registered Code"="MSCNC-DTTBE-XOGKT-VJFMR-INELC"

name: HLMSP5842
code: MSCNC-DDJOG-OGQXF-BQSTE-LUVJC

name: SOFTREG12963
code: MSCNC-DDJOG-OGQXF-BQSTE-LUVJC

name：SOFTREG18182
code：MSCNC-JXUHJ-UBMLF-AFJRU-TQMML

name：SOFTREG13053
code：MSCNC-DTTBE-XOGKT-VJFMR-INELC

name: byms411724 　
sn：mscnc-xeyyi-LUiLd-aUjgr-kbrpp

Originally posted by gergermen at 2005-11-15 05:30 PM:
你可以咁做，打開NOTEPAD，輸入以下內容（NAME同CODE可以轉下面個QUOTE嘅內容，並存為.reg文件，跟住執行佢，再安裝兔子。